The irregularity of the load destribution by the contact line of the tumbling mill open gearing

User Rating:  / 0
PoorBest 

Authors:

B.V. Vinogradov, Dr. Sci. (Tech.), Professor, State Higher Educational Institution “Ukrainian State University of Chemical Technology”, Headof the Department of Theoretical Mechanics and Resistance of Materials, Dnepropetrovsk, Ukraine

Abstract:

Purpose. The improvement of the calculation technique, which allow us to calculate the tumbling mill open gearing taking into account the load features and partial teeth contact.

Methodology. The generalization of the experimental data of nonuniformity of load distribution by gear width to straight cylindrical gearing of tumbling mill.

Findings. The factors, which have effect to load distribution by contact line, the actual behavior of the tumbling mill open gearing loading, the features of stress calculation taking into account partial teeth contact have been established. It is shown that assembling conditions, resilience and face runout have main influence to irregularity of load distribution by contact line. It is established that the misalignment of axes caused by the seating descent is possible during the mill operation. It is determined experimentally that the load distribution by straight ring gear width is linear. The form of irregularity of load distribution various against the teeth pair connection. The teeth pair which is most loaded and has sufficient irregularity of load distribution, is existing. At the same time in most cases of contact the teeth contact not takes place at all width of ring gear. It is shown, that the rigidity of tumbling mill open gearing is lower than the rigidity which is presented in traditional techniques.

Originality. The low of load distribution by contact line of tumbling mill open gear has been established. The calculation technique of factor taking into account the nonuniformity of load distribution during partial teeth contact has been proposed.

Practical value. The basic data for the determination of factor taking into account the irregularity of load distribution by contact line has been determined. The features of the calculation of open gears taking into account the incomplete contact have been determined.

References:

1. Виноградов Б.В. Відкриті зубчасті передачі: монографія / Виноградов Б.В.– Дніпропетровськ: УДХТУ, 2004 – 141с.

Vinogradov, B. (2004), Vidkryti zubchasti peredachi [Opened Gearings], monograph, USUCT, Dnipropetrovsk, Ukraine.

2. ISO 6336-1, (1996), Calculation of Load Capacity of Spur and Helical Gears, Part 1: Basic Principles, Introduction and General Influence Factors, 90 p.

Files:
2014_5_vinogradov
Date 2014-11-10 Filesize 441.53 KB Download 1028

Visitors

6235616
Today
This Month
All days
70
62293
6235616

Guest Book

If you have questions, comments or suggestions, you can write them in our "Guest Book"

Registration data

ISSN (print) 2071-2227,
ISSN (online) 2223-2362.
Journal was registered by Ministry of Justice of Ukraine.
Registration number КВ No.17742-6592PR dated April 27, 2011.

Contacts

D.Yavornytskyi ave.,19, pavilion 3, room 24-а, Dnipro, 49005
Tel.: +38 (056) 746 32 79.
e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
You are here: Home Archive by field of science Mining mechanics The irregularity of the load destribution by the contact line of the tumbling mill open gearing