Науковий вісник НГУ

Heat exchange under the longitudinal movement of wet steam in finning heat exchangers

• 
• 

User Rating:  / 0

PoorBest 

Details

Category: Content №1 2024

Last Updated on 29 February 2024

Published on 30 November -0001

Hits: 2238

Authors:

V.O.Tuz, orcid.org/0000-0002-4691-4890, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, Kyiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

N.L.Lebed*, orcid.org/0000-0002-2194-4911, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, Kyiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

N.S.Kulesh, orcid.org/0000-0002-1325-518X, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, Kyiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

* Corresponding author e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

повний текст / full article

Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu. 2024, (1): 069 - 075

https://doi.org/10.33271/nvngu/2024-1/069

Abstract:

The paper is devoted to the study on hydrodynamics and heat exchange of two-phase medium. While designing technological equipment, when the wet steam is used as the operating medium, the features of the interaction between liquid drops and the heat exchange surface are not considered in most cases. In full, this applies to steam turbines operating on the wet steam whose moisture content depends on the primary and secondary removal of liquid drops from the separation blocks.

Purpose. Improving the method of calculation of recuperative heat exchangers, if wet steam is used as the operating medium.

Methodology. It is based on the analysis of the physical model of moving the two-phase medium in the heat and mass exchange conditions, considering the design characteristics of the heat transfer surface.

Findings. The correlation of critical values of two-phase flow parameters was obtained to determine the lower boundary of the process of plucking the drops from the liquid film depending on the irrigation density, geometric characteristics of the channel and physical properties of the liquid and gas. Correlations were obtained for pipes with longitudinal finning as the Π-shaped profile, based on which we recommend optimizing the geometric characteristics of longitudinal finning.

Originality. Determining the limit modes of secondary removal formation during the movement of a two-phase medium in separation devices and the features of heat and mass transfer of wet steam in finning recuperative heat exchangers.

Practical value. The presented results make it possible to optimize the design of recuperative heat exchangers with longitudinal Π-shaped finning.

Keywords: hydrodynamics of movement, two-phase flow, recuperative heat exchanger, wet steam

References.

1. Bezrodnyi, M. K., Barabash, P. A., & Goliyad, N. N. (2017). Hydrodynamics and contact heat and mass transfer in gas-liquid systems: monography, (2 ^nd ed). Kyiv: Polytechnic. ISBN 978-966-622-856-3.

2. Tuz, V. O., & Lebed, N. L. (2018). Hydrodynamics and heat-mass exchange of gas-liquid flows on capillary-porous structures: monography. Kharkiv: FOP Brovin O.V. ISBN 978-617-7555-33-8.

3. Lixin, C. (2014). Frontiers and Progress in Multiphase Flow I: Book. Springer. https://doi.org/10.1007/978-3-319-04358-6.

4. Min, C., Luo, K., Changxiao, S., Haiou, W., Fan, J., & Fan, J. (2019). Interface-resolved detailed numerical simulation of evaporating two-phase flows with robin boundary conditions on irregular domains. International Journal of Heat and Mass Transfer, 145, 118774. https://doi.org/10.1016/j.ijheatmasstransfer.2019.118774.

5. Cossali, G. E., & Tonini, S. (2020). Analytical modelling of drop heating and evaporation in drop clouds: Effect of temperature dependent gas properties and cloud shape. International Journal of Heat and Mass Transfer, 162, 120315. https://doi.org/10.1016/j.ijheatmasstransfer.2020.120315.

6. Yi, Z., Guanmin, Z., Xiaohang, Q., & Maocheng, T. (2020). Three-dimensional numerical simulation of gas-liquid falling film flow characteristics on the airside of finned-tube heat exchanger with a typical large fin pitch. International Journal of Heat and Mass Transfer, 162, 120347. https://doi.org/10.1016/j.ijheatmasstransfer.2020.120347.

7. Guohui, Z., Baolong, W., Xianting, L., Wenxing, S., & Yang, C. (2019). Review of experimentation and modeling of heat and mass transfer performance of fin-and-tube heat exchangers with dehumidification. Applied Thermal Engineering, 146, 701-717. https://doi.org/10.1016/j.applthermaleng.2018.10.032.

8. Bruno, F. P., Jader, R. B. Jr., Luciana, W., & Massoud, K. (2012). Experimental study of two-phase flow structure in churn-turbulent to annular flows. Experimental Thermal and Fluid Science, 55, 7838-7846. https://doi.org/10.1016/j.ijheatmasstransfer.2012.08.021.

9. Worachest, P., Chi-Chuan, W., & Somchai, W. (2015). The new mathematical models for plain fin-and-tube heat exchangers with dehumidification. International Journal of Heat and Mass Transfer, 137, 031801. https://doi.org/10.1115/1.4029037.

10. Nae-Hyun, K., Kang-Jong, L., & Yeong-Bin, J. (2014). Airside performance of oval tube heat exchangers having sine wave fins under wet condition. Applied Thermal Engineering, 66, 580-589. https://doi.org/10.1016/j.applthermaleng.2014.02.042.

11. Xiaokui, M., Guoliang, D., Yuanming, Z., & Kaijian, W. (2017). Airside heat transfer and friction characteristics for enhanced fin-and-tube heat exchanger with hydrophilic coating under wet conditions. Transfert de chaleur côté air et caractéristiques de frottement d’un échangeur à tubes ailetés muni d’un enrobage hydrophile sous des conditions mouillées. International Journal of Refrigeration, 30, 1153-1167. https://doi.org/10.1016/j.ijrefrig.2007.03.001.

12. Simin, W., Guanping, J., Jiarui, W., Lijuan, S., & Jian, W. (2018). Application of entransy-dissipation-based thermal resistance for performance optimization of spiral-wound heat exchanger. International Journal of Heat and Mass Transfer, 116, 743-750. https://doi.org/10.1016/j.ijheatmasstransfer.2017.09.061.

13. Yi, Z., Guanmin, Z., Xiaohang, Q., & Maocheng, T. (2020). Three-dimensional numerical simulation of gas-liquid falling film flow characteristics on the airside of finned-tube heat exchanger with a typical large fin pitch. International Journal of Heat and Mass Transfer, 162, 120347. https://doi.org/10.1016/j.ijheatmasstransfer.2020.120347.

14. Melnyk, R. S., Nikolaenko, Y. E., Alekseik, Y. S., & Kravets, V. Y. (2017). Heat transfer limitations of heat pipes for a cooling systems of electronic components. 2017 IEEE 1^st Ukraine Conference on Electrical and Computer Engineering, UKRCON 2017 – Proceedings, 692-695. https://doi.org/10.1109/UKRCON.2017.8100316.

15. Lishchyshyn, V., Volzniuk, M., Vorobyov, M., Pismennyi, E., & Rudenko, A. (2022). Contact thermal resistance between the fin and pipe-base for composite heat transfer surfaces. POWER ENGINEERING: Economics, Technique, Ecology, (1), 65-71. https://doi.org/10.20535/1813-5420.1.2022.259193.

• < Prev
• Next >