Hydrodynamics of vapor-liquid flows in curvilined channels of separation devices of power plants
- Details
- Parent Category: 2023
- Category: Content №4 2023
- Created on 28 August 2023
- Last Updated on 28 August 2023
- Published on 30 November -0001
- Written by V. O. Tuz, N. L. Lebed, N. S. Kulesh
- Hits: 2948
Authors:
V.O.Tuz, orcid.org/0000-0002-4691-4890, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, Kyiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
N.L.Lebed*, orcid.org/0000-0002-2194-4911, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, Kyiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
N.S.Kulesh, orcid.org/0000-0002-1325-518X, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, Kyiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
* Corresponding author e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu. 2023, (4): 068 - 073
https://doi.org/10.33271/nvngu/2023-4/068
Abstract:
The main factor that affects the efficiency of the separation process is the lack of contact with the surface of the shutter when moving in the flow of small droplets of wet steam. This process depends on the physical and chemical properties of the wet vapor, the dispersion of the droplets, the parameters of the movement of the two-phase medium, adhesion and edge angle, and the geometry of the channel.
Purpose. Determination of the limit modes of operation of separation shutter devices depending on the dispersion and quantity of droplet liquid, flow parameters and geometric characteristics of curved channels.
Methodology. The methodology is based on the analysis of the physical model of the movement of a two-phase medium under the action of mass and gravitational forces in a curved horizontal channel.
Findings. A mathematical model is presented for determining the trajectory of a liquid droplet in a curvilinear corrugation channel of the louvered package of a separator-superheater. The main conditions of film destruction and dynamic droplet break-up are defined. A method for expanding the range of stable operation of separation devices is proposed. Based on the obtained correlations, the design of the blind package is optimized.
Originality. Based on the analysis of the physical model of the movement of a two-phase medium in a curved horizontal channel, a mathematical model was developed and the limit of capture of the dispersed phase was determined.
Practical value. The presented results allow optimization of separation devices of boiler drums, horizontal steam generators and steam superheater separators of the II circuit of VVER-1000, fuel preparation systems of GTU.
Keywords: two-phase medium, shutter separator, curvilinear movement of a drop, hydraulic mal distribution
References.
1. Oliver, P. (2013). Prediction of Rotating Instabilities in Low Pressure Steam Turbines Operating at Low Load. Journal of Engineering for Gas Turbines and Power, 144(9), 091007. https://doi.org/10.1115/1.4055017.
2. Takanori, S., Hisataka, F., & Kiyoshi, S. (2019). Improvement of Steam Turbine Stage Efficiency by Controlling Rotor Shroud Leakage Flows – Part I: Design Concept and Typical Performance of a Swirl Breaker. Journal of Engineering for Gas Turbines and Power,141(4), 041002. https://doi.org/10.1115/1.4041650.
3. Koichi, Y., Tomoki, K., Masahiro, T., Genki, N., Kazuyasu, S., Katsuhiko, S., & Shuichi, U. (2019). Degradation of Aerodynamic Performance of an Intermediate-Pressure Steam Turbine Due to Erosion of Nozzle Guide Vanes and Rotor Blades. Journal of Engineering for Gas Turbines and Power, 141(1), 012602. https://doi.org/10.1115/1.4040566.
4. Kulkowski, K., Grochowsk, M., Duzinkiewicz, K., & Kobylarz, A. (2017). Nuclear power plant steam turbine — Modeling for model based control purposes. Applied Mathematical Modelling, 48, 491-515. https://doi.org/10.1016/j.apm.2017.04.008.
5. Leyzerovich, А. (2005). Wet-Steam Turbines for Nuclear Power Plants PennWell Corporation. ISBN-13: 978-1593700324.
6. Pis’mennyi, E., Polupan, G., Ignacio Carvajial-Mariscal, I., Sanchez‒Silva, F., & Pioro, I. (2016). Handbook for Transversely Finned Tube Heat Exchanger Design. Academic Press. https://doi.org/10.1016/C2014-0-02659-7.
7. Tuz, V., Lebed, N., & Lebed, I. (2014). Hydrodynamics of separation devices of the NPP technological equipment. Nuclear and Radiation Safety, 2(62), 22-26. https://doi.org/10.32918/nrs.2014.2(62).05.
8. Mohamed, M. A., & Soliman, H. M. (2022). Experimental investigation of gas-liquid separation with a new combined impacting junction. Experimental Thermal and Fluid Science, 131, 110527. https://doi.org/10.1016/j.expthermflusci.2021.110527.
9. Zhu, Q., Wang, G., Schlegel, J. P., Yan, Y., Yang, X., Liu, Y., Ishii, M., & Buchanan, J. R. (2021). Experimental study of two-phase flow structure in churn-turbulent to annular flows. Experimental Thermal and Fluid Science, 129, 110397. https://doi.org/10.1016/j.expthermflusci.2021.110397.
10. Feng, Z., Li, H., Liu, J., Ni, S., & Wang, S. (2021). Experimental investigation on gas-liquid two-phase flow distribution characteristics in parallel multiple channels. Experimental Thermal and Fluid Science, 127, 110415. https://doi.org/10.1016/j.expthermflusci.2021.110415.
11. Dassler, C., & Janoske, U. (2019). Experimental investigation of single- and two-phase pressure drop in slender rectangular 180° return bends. Experimental Thermal and Fluid Science, 103, 126-132. https://doi.org/10.1016/j.expthermflusci.2019.01.001.
12. Hayashi, K., Kazi, J., Yoshida, N., & Tomiyama, A. (2020). Pressure drops of air-water two-phase flows in horizontal U-bends. International Journal of Multiphase Flow, 131, 103403. https://doi.org/10.1016/j.ijmultiphaseflow.2020.103403.
13. Malhotra, S., & Ghosh, S. (2019). Effects of channel diameter on flow pattern and pressure drop for air–water flow in serpentine gas channels of PEM fuel cell-An Ex situ experiment. Experimental Thermal and Fluid Science, 100, 233-250. https://doi.org/10.1016/j.expthermflusci.2018.09.006.
14. Bezrodnyi, M. K., Barabash, P. A., & Goliyad, N. N. (2017). Hydrodynamics and contact heat and mass transfer in gas-liquid systems: monography (2 nd ed.). Kyiv: Polytechnic. ISBN 978-966-622-856-3.
Newer news items:
- Investigation of combined ensemble methods for diagnostics of the quality of interaction of human-machine systems - 28/08/2023 20:15
- Сompetitiveness assessment of the railway network of Кazakhstan in the performance of transit container transportation - 28/08/2023 20:15
- Utilization of the secondary resources of titanium-zirconium pits when constructing highways - 28/08/2023 20:15
- The role of the formation of the environmental management system in the improvement of international economic relations - 28/08/2023 20:15
- Improving a process of managing dynamic occupational risks - 28/08/2023 20:15
- Soil contamination status using contamination indicators and the health risk - 28/08/2023 20:15
- Parameterization of the statistical model for electrical energy efficiency control - 28/08/2023 20:15
- Energy transition: the future of energy on the base of smart specialization - 28/08/2023 20:15
- Designing the working surfaces of rotary planetary mechanisms - 28/08/2023 20:15
- Improvement of the service life of mining and industrial equipment by using friction modifiers - 28/08/2023 20:15
Older news items:
- Substantiating a method for computer analysis of the stress-strain state of the tubbing erector manipulator mechanism - 28/08/2023 20:15
- Application of the stereomicrophotogrammetric method for the complex study of the Al-Cu-Mg alloys system - 28/08/2023 20:15
- Magnetic stimulation of chemical reactions in coal - 28/08/2023 20:15
- Selection and justification of drilling and blasting parameters using genetic algorithms - 28/08/2023 20:15
- Improving the technology of extracting coal concentrate from fly ash from thermal power plants - 28/08/2023 20:15
- A new mining method for reopening the opencast mine of Kef Essennoun - 28/08/2023 20:15
- Tectonics and gravity field structure of Central Kazakhstan - 28/08/2023 20:15
- Mining and geological models of virtual complex ore blocks of the bench - 28/08/2023 20:15
- Predicting zones of increased water inflows in local folded structures - 28/08/2023 20:15