Науковий вісник НГУ

Hydrodynamics of vapor-liquid flows in curvilined channels of separation devices of power plants

• 
• 

User Rating:  / 1

PoorBest 

Details

Category: Content №4 2023

Last Updated on 28 August 2023

Published on 30 November -0001

Hits: 3109

Authors:

V.O.Tuz, orcid.org/0000-0002-4691-4890, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, Kyiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

N.L.Lebed*, orcid.org/0000-0002-2194-4911, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, Kyiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

N.S.Kulesh, orcid.org/0000-0002-1325-518X, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, Kyiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

* Corresponding author e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

повний текст / full article

Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu. 2023, (4): 068 - 073

https://doi.org/10.33271/nvngu/2023-4/068

Abstract:

The main factor that affects the efficiency of the separation process is the lack of contact with the surface of the shutter when moving in the flow of small droplets of wet steam. This process depends on the physical and chemical properties of the wet vapor, the dispersion of the droplets, the parameters of the movement of the two-phase medium, adhesion and edge angle, and the geometry of the channel.

Purpose. Determination of the limit modes of operation of separation shutter devices depending on the dispersion and quantity of droplet liquid, flow parameters and geometric characteristics of curved channels.

Methodology. The methodology is based on the analysis of the physical model of the movement of a two-phase medium under the action of mass and gravitational forces in a curved horizontal channel.

Findings. A mathematical model is presented for determining the trajectory of a liquid droplet in a curvilinear corrugation channel of the louvered package of a separator-superheater. The main conditions of film destruction and dynamic droplet break-up are defined. A method for expanding the range of stable operation of separation devices is proposed. Based on the obtained correlations, the design of the blind package is optimized.

Originality. Based on the analysis of the physical model of the movement of a two-phase medium in a curved horizontal channel, a mathematical model was developed and the limit of capture of the dispersed phase was determined.

Practical value. The presented results allow optimization of separation devices of boiler drums, horizontal steam generators and steam superheater separators of the II circuit of VVER-1000, fuel preparation systems of GTU.

Keywords: two-phase medium, shutter separator, curvilinear movement of a drop, hydraulic mal distribution

References.

1. Oliver, P. (2013). Prediction of Rotating Instabilities in Low Pressure Steam Turbines Operating at Low Load. Journal of Engineering for Gas Turbines and Power, 144(9), 091007. https://doi.org/10.1115/1.4055017.

2. Takanori, S., Hisataka, F., & Kiyoshi, S. (2019). Improvement of Steam Turbine Stage Efficiency by Controlling Rotor Shroud Leakage Flows – Part I: Design Concept and Typical Performance of a Swirl Breaker. Journal of Engineering for Gas Turbines and Power,141(4), 041002. https://doi.org/10.1115/1.4041650.

3. Koichi, Y., Tomoki, K., Masahiro, T., Genki, N., Kazuyasu, S., Katsuhiko, S., & Shuichi, U. (2019). Degradation of Aerodynamic Performance of an Intermediate-Pressure Steam Turbine Due to Erosion of Nozzle Guide Vanes and Rotor Blades. Journal of Engineering for Gas Turbines and Power, 141(1), 012602. https://doi.org/10.1115/1.4040566.

4. Kulkowski, K., Grochowsk, M., Duzinkiewicz, K., & Kobylarz, A. (2017). Nuclear power plant steam turbine — Modeling for model based control purposes. Applied Mathematical Modelling, 48, 491-515. https://doi.org/10.1016/j.apm.2017.04.008.

5. Leyzerovich, А. (2005). Wet-Steam Turbines for Nuclear Power Plants PennWell Corporation. ISBN-13: 978-1593700324.

6. Pis’mennyi, E., Polupan, G., Ignacio Carvajial-Mariscal, I., Sanchez‒Silva, F., & Pioro, I. (2016). Handbook for Transversely Finned Tube Heat Exchanger Design. Academic Press. https://doi.org/10.1016/C2014-0-02659-7.

7. Tuz, V., Lebed, N., & Lebed, I. (2014). Hydrodynamics of separation devices of the NPP technological equipment. Nuclear and Radiation Safety, 2(62), 22-26. https://doi.org/10.32918/nrs.2014.2(62).05.

8. Mohamed, M. A., & Soliman, H. M. (2022). Experimental investigation of gas-liquid separation with a new combined impacting junction. Experimental Thermal and Fluid Science, 131, 110527. https://doi.org/10.1016/j.expthermflusci.2021.110527.

9. Zhu, Q., Wang, G., Schlegel, J. P., Yan, Y., Yang, X., Liu, Y., Ishii, M., & Buchanan, J. R. (2021). Experimental study of two-phase flow structure in churn-turbulent to annular flows. Experimental Thermal and Fluid Science, 129, 110397. https://doi.org/10.1016/j.expthermflusci.2021.110397.

10. Feng, Z., Li, H., Liu, J., Ni, S., & Wang, S. (2021). Experimental investigation on gas-liquid two-phase flow distribution characteristics in parallel multiple channels. Experimental Thermal and Fluid Science, 127, 110415. https://doi.org/10.1016/j.expthermflusci.2021.110415.

11. Dassler, C., & Janoske, U. (2019). Experimental investigation of single- and two-phase pressure drop in slender rectangular 180° return bends. Experimental Thermal and Fluid Science, 103, 126-132. https://doi.org/10.1016/j.expthermflusci.2019.01.001.

12. Hayashi, K., Kazi, J., Yoshida, N., & Tomiyama, A. (2020). Pressure drops of air-water two-phase flows in horizontal U-bends. International Journal of Multiphase Flow, 131, 103403. https://doi.org/10.1016/j.ijmultiphaseflow.2020.103403.

13. Malhotra, S., & Ghosh, S. (2019). Effects of channel diameter on flow pattern and pressure drop for air–water flow in serpentine gas channels of PEM fuel cell-An Ex situ experiment. Experimental Thermal and Fluid Science, 100, 233-250. https://doi.org/10.1016/j.expthermflusci.2018.09.006.

14. Bezrodnyi, M. K., Barabash, P. A., & Goliyad, N. N. (2017). Hydrodynamics and contact heat and mass transfer in gas-liquid systems: monography (2 ^nd ed.). Kyiv: Polytechnic. ISBN 978-966-622-856-3.

• < Prev
• Next >