- 41. Mathematical model of oscillations of a drill tool with a drill bit of cutting-scraping type
- (Content №1 2020)
- ... the forces of cutting and friction on the bit from the second derivatives of the independent generalized coordinates of the mechanical system over time, as well as the relationship between the generalized ...
- Created on 10 March 2020
- 42. Model of surface roughness in turning of shafts of traction motors of electric carst
- (Content №1 2020)
- ... текст / full article Abstract: Purpose. Research on surface roughness in turning of traction motor shaft of electric vehicles, depending on the measure of the main cutting edge angle ...
- Created on 10 March 2020
- 43. Mathematical model of heat processes in terms of gas-saturated rock breaking by means of shearers and tunneling machines
- (Content №1 2020)
- Authors: Ya. Ya. Lebediev, Cand. Sc. (Tech.), Assoc. Prof., orcid.org/0000-0002-2992-2581, Dnipro University of Technology, Dnipro, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it. O.V.Stolbchenko, Cand. ...
- Created on 10 March 2020
- 44. Results of testing and modelling the “drilling rig with hydraulic vibrator ‒ rock” system
- (Content №1 2020)
- ... from https://www.onepetro.org/conference-paper/ARMA-2016-451. 8. Babapour, S., & Butt, S. D. (2014). Investigation of Enhancing Drill cuttings Cleaning and Penetration Rate Using Cavitating Pressure ...
- Created on 10 March 2020
- 45. Contens 05 2019
- (Contens №5 2019)
- ... S.V.Boyko, P.L.Ignatenko.Determination of instantaneous temperature in the cutting zone during abrasive processing 35 D.E.Boudjellal, A.Hafsaoui, ...
- Created on 10 November 2019
- 46. Integrated control system of the thermal power complex using the tensor analysis methods
- (Information Technologies, Systems Analysis and Administration)
- ... & Gruhler, G. (2015). Automated stabilization of loading capacity of coal shearer screw with controlled cutting drive. In New Developments in Mining Engineering Theoretical and Practical Solutions ...
- Created on 26 October 2019
- 47. Determination of instantaneous temperature in the cutting zone during abrasive processing
- (Geotechnical and mining mechanical engineering, machine building)
- ... research on the temperature state in the cutting zone for abrasive grinding and mathematical modeling of the stress-strain state of the workpiece surface under the influence of the determined temperature ...
- Created on 26 October 2019
- 48. Comprehensive solution of recycling waste from stone processing industry
- (Environmental Safety, Labour Protection)
- ... cuttings) by specialized dump trucks equipped with grabbing petrol buckets and dump-shaped reinforced bodies is substantiated. The technology of the preparation of oversized raw materials for further grinding ...
- Created on 19 August 2019
- 49. Automation of the control process of the mining machines based on fuzzy logic
- (Information Technologies)
- ... (2015). Automated stabilization of loading capacity of coal shearer screw with controlled cutting drive. New Developments in Mining Engineering 2015: Theoretical and Practical Solutions of Mineral Resources ...
- Created on 16 June 2019
- 50. Improving the efficiency of using dump trucks under conditions of career at open mining works
- (Geotechnical and mining mechanical engineering, machine building)
- ... length and slope angles were established. This allows improving the process according to the criterion of surmounted elevated slopes of open pit transport inclines, cutting their length almost by half, ...
- Created on 24 April 2019