Kinetics of quartz sand and its mixtures drying by microwave radiation

User Rating:  / 0
PoorBest 

Authors:


L.I.Solonenko, orcid.org/0000-0003-2092-8044, Odesa National Polytechnic University, Odesa, Ukraine, -mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

S.I.Repiakh, orcid.org/0000-0003-0203-4135, National Metallurgical Academy of Ukraine, Dnipro, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

K.I.Uzlov, orcid.org/0000-0003-0744-9890, National Metallurgical Academy of Ukraine, Dnipro, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

I.Mamuzich, orcid.org/0000-0002-7968-7540, University of Zagreb, Croatian metallurgical society, Zagreb, the Republic of Croatia, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

T.V.Kimstach, orcid.org/0000-0002-8993-201X, National Metallurgical Academy of Ukraine, Dnipro, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

O.P.Bilyi, orcid.org/0000-0003-1234-5404, National Metallurgical Academy of Ukraine, Dnipro, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.


повний текст / full article



Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu. 2021, (1): 068 - 077

https://doi.org/10.33271/nvngu/2021-1/068



Abstract:



Purpose.
Kinetics research and description of drying by microwave radiation mechanism development of quartz sand and its mixes with sodium silicate in limited quantity of water steam medium.


Methodology.
Distilled water, sodium silicate solute and quartz sand have been used in this research. Study has been performed on sand samples weighing 200 g. Mixtures drying and structuring have been performed by microwave radiation with power of 700W with frequency of 2.45 GHz in air and in saturated water weighing 1 g steam medium. Accuracy of temperature measurement is 1, mass is 0.02 g. Realized in this investigation drying kinetics has been specified as specimen weight change dependence and moisture evaporation from this mixture rate vs. drying duration. Dependencies have been built on the results of video recording and corresponding chrono-gravimetric measurements data digitalization. Mixtures during heating by microwave radiation temperature changes registration has been performed with an interval of 1560 s. Samples average heating rate has been estimated by calculation based on results in their temperature change determination during first 2 minutes of heating with microwave radiation.


Findings.
For the first time, microwave drying kinetics of quartz sand and its mixtures with sodium silicate in limited water medium (structured by SMS-process) has been studied. For the first time, based on SMS-process material balance, analytical dependence has been developed. This dependence application allows sand-sodium-silicate mixture structured by SMS-process maximum mass to calculate when using sodium silicate solute (silicate module 2.83.0) for quartz sand cladding and 1 g of saturated water steam for mixture structuring. It has been established that when mixtures structuring according to SMS-process water extraction from them takes place in three stages at ~100, 100108 and at 125138 . Maximum appropriate heating temperature of sand-sodium-silicate mixture during structuring by SMS-process has been recommended as ~125 . Exceeding of specified temperature leads to hydrated water from mixture releasing in steam form and its condensation on colder working surface of model-rod rigging. Resulting condensate leads to mixture restructuring in contact with equipment places and, accordingly, sharp quality deterioration in prepared molds and rods. For manufactured molds and rods quality stabilization, it has been recommended to pre-dry the quartz sand cladded with sodium silicate solute in microwave field for at least 3 minutes before structuring according to SMS-process.


Originality.
For the first time, data on drying kinetics has been obtained and quartz sand and its mixtures with sodium silicate in limited water steam medium microwave drying mechanism description has been developed. Influence of number of SMS-process basic parameters on structured quartz sand weight regularities has been established.


Practical value.
Research results will be useful in terms of ideas expanding about the processes that accompany granular materials drying, as well as in technologies and equipment for drying and structuring fine-grained dielectric materials and their mixtures development, creating new capillary-porous media, etc. under microwave radiation influence.



Keywords:
kinetics, drying, sand, sodium silicate, steam, structuring, microwave radiation

References.


1. Yashina, S.A., & Klyukova, T.D. (2018). Study on the mechanism of crumbling of self-hardening mixtures (review). VIAM Proceedings, 6(66), 110-118. ISSN 2307-6046.

2. Solonenko, L., Prokopovich, I., Repyakh, S., Sukhoi, K., & Dmytrenko, D. (2019). System analysis of modern areas of increasing environmental and sanitary hygienic safety of using cold hardening mixtures in foundry.Odessa Polytechnic University, Proceedings, (57), 90-98. ISSN2076-2429.

3. Shnaider, S.E., & Varnikov, Yu.A. (2018). Some features of the kinetics of liquid dispersed products in the foamed state. Science without borders, 10(27), 83-86. ISSN 2500-1191.

4. Alshanski, A., & Kotow, A. (2020). Head and mass transfer during convective drying of thin flat wet materials. Vestnik of Vitebsk state technological university, 1(38), 79-90. https://doi.org/10.24411/2079-7958-2020-13808.

5. Volkhonov, M., Jabbarov, I., Soldatov, V., & Smirnov, I. (2018). Development of the method of exposure control of grain drying in high-temperature dryers. Eastern-European Journal of Enterprise Technologies, 3(93), 22-29. https://doi.org/10.15587/1729-4061.2018.133607.

6. Alekseev, G.V., Egorova, O.A., Leeuw, A.G., & Derkanosova, A.A. (2017). Specifics of powdered food products drying in a fluidized. Bulletin of the South Ural State University. Series Food and Biotechnology, 4, 34-40. ISSN 2310-2748.

7. Kodylev, A.V., Lozinov, A.N., & Sadykov, R.A. (2016). Kinetics of convective drying of bulk and dispersed building materials in a drying unit with heat carrier recovery. News of KSUAE, 4(38), 308-313. ISSN 2073-1523.

8. Efremov, G.I., & Geller, J.A. (2018). Modeling of drying materials for building ceramics. Bulletin of the Moscow Information Technology University Moscow Institute of Architecture and Civil Engineering, 1, 14-19. ISSN 2619-046X.

9. Antipov, S.T., Toroptsev, V.V., Martekha, A.N., Berestovoy, A.A., & Yurova, I.S. (2019). Kinetics of the drying process of fermented wheat raw materials in a vibratory boiling layer. Proceedings of VSUET, 81(4), 17-21. ISSN 2226-910.

10. Gavrilova, N.D., & Malyshkina, I.A. (2018). The influence of changes in the structure of hydrogen bonds of water on the electrophysical properties of matrixwater systems in stepwise heating. Moscow University Physics Bulletin, 6, 74-80. ISSN 0579-9392.

11. Salomatov, V.V., Karelin, V.A., & Salomatov, V.V. (2019). Electromagnetic drying of wet materials with microvave low penetration depth in condition of heat removal by radiation and convection. I. Warm up phase. Bulletin of the Tomsk Polytechnic University. Geo ssets Engineering, 330(12), 119-125. https://doi.org/10.18799/24731830/2019/12/2408.

12. Kramarenko, V.V., Nikitenkov, A.N., & Molokov, V.Yu. (2017). Applicability of microwave method for determining soil moisture. Bulletin of the Tomsk Polytechnic University. Geo ssets Engineering, 328(11), 60-74. ISSN 2500-1019.

13. Solonenko, L.I., Bilyi, O.P., Repiakh, S.I., Kimstach,T.V., & Uzlov, .I. (2020). Heating rate of granular inorganic materials by microwave radiation. Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, (2), 37-41. https://doi.org/10.33271/nvngu/2020-2/037.

14. Klimenko,V.G. (n.d.). (2017). The role of Na, K, Ca2, NH4 sulfates-based double salts in derivation of anhydrite binders. Vestnik BGTU im. V.G.uhova, 12, 119-125. https://doi.org/10.12737/article_5a27cb84ae0049.79523605.

15. Illarionov, I.E., Strelnikov, I.A., Gartfelder, V.A., Korolev, A.V., & Gilmashina, T.R. (2018). Development and application of metal phosphate binders for the production of molding, core and heat-insulating mixtures and coatings. Theory and technology of metallurgical production, 4(27), 4-10. ISSN 2311-5378.

16. Fedotov, A.A., Vakhnina, T.N., Titunin, A.A., & Sviridov, A.V. (2020). Study of the influence of stabilizers on the properties of carbamide formaldehyde binder and FC plywood. Forestry journal, 1, 136-143. https://doi.org/10.3422/issn.2222-7962/2020.1/14.

17. Krutilin, A.N., Guminski, Yu.Yu., & Rusevich, O.A. (2018). Improving the efficiency of using liquid-glass mixtures. Part 4. Combined strengthening. Foundry production and metallurgy, 4(93), 38-44. https://doi.org/10.21122/1638-6065-2018-4-38-44.

18. Repyakh, S.I., Solonenko, L.I., Biliy, O.P., Usenko,R.V., & Uzlov, K.I. (2019). The power and structure of the components in food-and-business formal sums. Theory and practice, 1, 81-92. ISSN 1028-2335.

19. Grimzin, I., Ponomarenko, O., Marynenko, D., Yevtushenko, N., & Berlizeva, T. (2019). The technological process of obtaining sand-plaster molds for complex thin-walled aluminum casting. Advanced Manufacturing Processes: Selected Papers from the Grabchenkos international conference on advanced manufacturing process, (pp. 405-414). InterPartner 2019, LNME. https://doi.org/10.1007/978-3-030-40724-7.

20. Solonenko, L.I., Repyakh, S.I., & Uzlov, K.I. (2019). Kinetics of the structure of the food-borne sums of steam-microchilles solidification. Theory and practice, 4, 44-56. ISSN 1028-2335.

 

Visitors

6227394
Today
This Month
All days
1226
54071
6227394

Guest Book

If you have questions, comments or suggestions, you can write them in our "Guest Book"

Registration data

ISSN (print) 2071-2227,
ISSN (online) 2223-2362.
Journal was registered by Ministry of Justice of Ukraine.
Registration number КВ No.17742-6592PR dated April 27, 2011.

Contacts

D.Yavornytskyi ave.,19, pavilion 3, room 24-а, Dnipro, 49005
Tel.: +38 (056) 746 32 79.
e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
You are here: Home About the journal editorial board EngCat Archive 2021 Content №1 2021 Kinetics of quartz sand and its mixtures drying by microwave radiation