Innovative technique for evaluating electric power distortion in cable transmission line

User Rating:  / 0
PoorBest 

Authors:

О.Bialobrzheskyi, Cand. Sc.(Tech.), Assoc. Prof., orcid.org/0000-0003-1669-4580, Kremenchuk Mykhailo Ostrohradskyi National University, Kremenchuk, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

S.Bondarenko, orcid.org/0000-0002-6224-2123, Kremenchuk Mykhailo Ostrohradskyi National University, Kremenchuk, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

S.Yakymets, Cand. Sc. (Tech.), Assoc. Prof., orcid.org/0000-0002-2797-2796, Kremenchuk Mykhailo Ostrohradskyi National University, Kremenchuk, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu. 2020, (1):58-63
https://doi.org/10.33271/nvngu/2020-1/058

 повний текст / full article



Abstract:

 

Purpose.The rationale for use of electrical power components produced by current and voltage harmonics with different frequencies to assess its impact on the electrical energy transmission process.

Methodology. PI-section equivalent circuit of the cable line is used. Insulation conductivity is assumed to be infinitely small. Using the results of known studies, the change in active resistance with increasing current frequency is taken into account. The cable power line is represented by a quadripole, whose equations are written in the A-form. With the constant voltage composition at the end of the line, for two cases of alternating non-sinusoidal current at the end of the line, its similar current value and the nonlinear distortion coefficient, the quadripole mode parameters are calculated. Based on the obtained parameters of the line mode, according to the existing methods for determining the power components, their numerical calculation was performed. According to the results of the analysis obtained power components for the two cases, their concurrency at the beginning of the line and the discrepancy at the end of the line were noted. Based on this, a conclusion was drawn on the low information content of power components calculated by the known method.

Findings. Using an alternative method for determining the components of instantaneous power, depending on the combination of harmonic frequencies of current and voltage, a number of power distortion indicators are proposed. At the same time active and reactive powers are traditionally used. Performing a numerical calculation of the indicated power indices for the power line, under the conditions of two previously agreed experiments, their effectiveness is demonstrated. It is noted that for the conditions of conducted numerical experiments, the indices of the share of pseudo-canonical and non-canonical components differ significantly depending on the distribution of the amplitudes of current harmonics for the same current value, and the nonlinear distortion coefficient

Originality. The theory of instantaneous electrical power has been developed in terms of power distortion indicators, determined taking into account the combination of frequencies of polyharmonic current and voltage in single-phase electrical systems.

Practical value. Innovative indicators of electrical power distortion, obtained based on the analysis of the composition of instantaneous power, reflect the low quality of electrical energy. Additional introduction of the proposed indicators into the electricity metering procedure is a prerequisite for motivating participants in the process to improve quality.

References.

1. Zhezhelenko, I. V. (2018). The main directions of improving the efficiency of production, transmission and distribution of electrical energy]. Energetika. Proc. CIS Higher Educ. Inst. and Power Eng. Assoc., 61(1), 28-35. https://doi.org/10.21122/1029-7448-2018-61-1-28-35.

2. Toups, T. N., & Czarnecki, L. S. (2014). Advanced metering infrastructure’s measurement of working, reflected, and detrimental active power in microgrids. 2014 IEEE Green Energy and Systems Conference (IGESC), Long Beach, CA, (pp. 41-46). https://doi.org/10.1109/IGESC.2014.7018638.

3. Plakhtii, А. (2018). Analysis of power loss caused by higher harmonics in electrical supply systems. Bulletin of NTU “KhPI”. Series: New solutions in modern technologies, 26(1302), 1, 126-134, https://doi.org/10.20998/2413-4295.2018.26.18.

4. Sirotin, Yu. O., Gryb, O. G., & Gapon, D. A. (2017). Accounting inactive components of full-scale power. Bulletin of NTU “KhPI”. Series: System analysis, control and information technology, 42(948), 71-76.

5. Topolski, Ł., Warecki, J., & Hanzelka, Z. (2018). Methods for determining power losses in cable lines with non-linear load. Przeglad Elektrotechniczny, 94(9), 85-90. https://doi.org/10.15199/48.2018.09.21.

6. Milardovich, N., Prevosto, L., & Lara, M. A. (2014). Calculation of harmonic losses and ampacity in low-voltage power cables when used for feeding large LED lighting loads. Advanced Electromagnetics, 3(1), 50-56. https://doi.org/10.7716/aem.v3i1.258.

7. Averbukh, M. A., & Prasol, D. A. (2018). Influence of high-power nonlinear consumers on electric energy losses in mining high-voltage power line. IOP Conference Series: Materials Science and Engineering, 327(5), (pp.1-6). https://doi.org/10.1088/1757-899X/327/5/052028.

8. IEEE Standard Definitions for the Measurement of Electric Power Quantities Under Sinusoidal, Nonsinusoidal, Balanced, or Unbalanced Conditions in IEEE Std 1459-2010 (Revision of IEEE Std 1459-2000), (pp.1-50), March 19, 2010. https://doi.org/10.1109/IEEESTD.2010.5439063.

9. Zhemerov, G., Ilina, N., & Tugay, D. (2016) The theorem of minimum energy losses in three-phase four-wire energy supply system, 2016 2 nd International Conference on Intelligent Energy and Power Systems (IEPS), Kyiv, (pp. 1-3). https://doi.org/10.1109/IEPS.2016.7521889.

10. Zhemerov, G. G., & Tugay, D. V. (2015). Dependence of the additional losses in three-phase energy supply systems on reactive power and instantaneous active power pulsations. Tekhnichna Elektrodynamika, 4, 66-70.

11. Zagirnyak, M., Maliakova, M., & Kalinov, A. (2015). Analysis of electric circuits with semiconductor converters with the use of a small parameter method in frequency domain, COMPEL: The International Journal for Computation and Mathematics in Electrical and Electronic Engineering, 34(3), 808-823. https://doi.org/10.1108/COMPEL-10-2014-0260.

12. Bucci, G., Ciancetta, F., Fiorucci, E., & Ometto, A. (2017). Survey about Classical and Innovative Definitions of the Power Quantities Under Nonsinusoidal Conditions. International Journal of Emerging Electric Power Systems, 18(3), 1-16. https://doi.org/10.1515/ijeeps-2017-0002.

13. Bialobrzheskyi, О., Rod’kin, D., & Gladyr, A. (2018). Power components of electric energy for technical and commercial electricity metering. Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, (2), 70-79. https://doi.org/10.29202/nvngu/2018-2/10.

Visitors

3043102
Today
This Month
All days
93
3456
3043102

Guest Book

If you have questions, comments or suggestions, you can write them in our "Guest Book"

Registration data

ISSN (print) 2071-2227,
ISSN (online) 2223-2362.
Journal was registered by Ministry of Justice of Ukraine.
Registration number КВ No.17742-6592PR dated April 27, 2011.

Contacts

D.Yavornytskyi ave.,19, pavilion 3, room 24-а, Dnipro, 49005
Tel.: +38 (056) 746 32 79.
e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
You are here: Home About the journal contact EngCat Archive 2020 Content №1 2020 Innovative technique for evaluating electric power distortion in cable transmission line