Technological, lithological and economic aspects of data geometrization in coal mining

User Rating:  / 0
PoorBest 

Authors:

R.O.Dychkovskyi, Dr. Sc. (Tech.), Prof., orcid.org/0000-0002-3143-8940, Dnipro University of Technology, Dnipro, Ukraine, e‑mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

V.H.Lozynskyi, Cand. Sc. (Tech.), orcid.org/0000-0002-9657-0635, Dnipro University of Technology, Dnipro, Ukraine, e‑mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

P.B.Saik, Cand. Sc. (Tech.), orcid.org/0000-0001-7758-1083, Dnipro University of Technology, Dnipro, Ukraine, e‑mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Yu.V. Dubiei, Cand. Sc. (Econ.), orcid.org/0000-0003-3415-3470, Dnipro University of Technology, Dnipro, Ukraine, e‑mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

E.Cáceres Cabana, Cand. Sc. (Tech.), Assoc. Prof., orcid.org/0000-0002-0066-1349, Universidad Nacional de San Agustin de Arequipa, Institute of Renewable Energy Research and Energy Efficiency, Arequipa, Peru, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Ia.T.Shavarskyi, JARAD Recycling Technology Sp. z o.o., Smolnica, Poland, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Abstract:

Purpose. Creation of a favorable geomechanical situation and estimation of economical parameters at the mining area according to the selection of the relevant technical and technological justification and operating modes of the mechanized fastening based on the planning of zones of variable stresses.

Methodology. Methods of mathematical modeling for determination of loads for fastening of mechanized complexes, experimental studies on stressed-deformed state of the rock mass are applied, on the basis of which rational parameters of mining and management mining pressure are formed.

Findings. Using the developed method of data geometrization, the lithological and geological structure of the rock mass was restored on the intersections of the surrounding wallface two of preparatory workings. On this basis, a change in the stress-strain state of a rock massif is established. This makes it possible to set the loadings on the fastening of mechanized complexes. This approach establishes the mathematical dependencies that determine the zones of elevated and lowered mining pressure. For the measure of transition, the so-called coefficient of lithological difference is defined. This parameter provides the possibility not only to evaluate the geomechanical situation at the extraction site, but also to establish a marginal zone for the development of reserves with traditional and radical technologies. An economic evaluation of the proposed technical and technological measures has been held separately. The results of the research will allow justifying the effective mining of coal reserves in particular geological conditions.

Originality. The dependence of the lithological difference formation of rocks and stresses of the rockmass to create conditions for the development of the coal reserves has been established. An economic evaluation of the decisions was made using the well-known methodology of UNIDO.

Practical value. Obtained results of experimental studies with precision sufficient for practical application can be used to determine the parameters of underground mining and provide an opportunity to extract the coal reserves at an economically suitable level. The proposed technological solutions were checked in practical conditions for the development of the coal reserves at the site of a DTEK company mine.

References.

1. Lozynskyi, V., Dychkovskyi, R., Saik, P., & Falshtynskyi, V. (2018). Coal Seam Gasification in Faulting Zones (Heat and Mass Balance Study). Solid State Phenomena, (277), 66-79. DOI: 10.4028/www.scientific.net/SSP.277.66.

2. Petlovanyi, M. V. (2018). Modern experience of low-coal seams underground mining in Ukraine. International Journal of Mining Science and Technology, 28(6), 917-923. DOI: 10.1016/j.ijmst.2018.05.014.

3. Malanchuk, Ye., Korniienko, V., Moshynskyi, V., Soroka, V., Khrystyuk, A., & Malanchuk, Z. (2019). Regularities of hydromechanical amber extraction from sandy deposits. Mining of Mineral Deposits, 13(1), 49-57. DOI: 10.33271/mining13.01.049.

4. Bondarenko, V., Tabachenko, M., & Wachowicz, J. (2010). Possibility of production complex of sufficient gasses in Ukraine. New Techniques and Technologies in Mining, 113-119. DOI: 10.1201/b11329-1.

5. Cempa, M., & Smoliński, A. (2017). Reactivity of chars gasified in a fixed bed reactor with the potential utilization of excess process heat. Journal of Sustainable Mining, 16(4), 156-161. DOI: 10.1016/j.jsm.2017.12.001.

6. Gorova, A., Pavlychenko, A., Borysovs’ka, O., & Krup­s’ka, L. (2013). The development of methodology for assessment of environmental risk degree in mining regions. Annual Scientific-Technical Colletion ‒ Mining of Mineral Deposit, 207-209. DOI: 10.1201/b16354-38.

7. Khomenko, O., Kononenko, M., & Myronova, I. (2013). Blasting works technology to decrease an emission of harmful matters into the mine atmosphere. Annual Scientific-Technical Colletion ‒ Mining of Mineral Deposit, 231-235. DOI: 10.1201/b16354-43.

8. Golovchenko, A. (2018). Automated Monitoring of Physical Processes of Formation of Burden Material Surface and Gas Flow in Blast Furnace, Solid State Phenomena, (277), 54-65. DOI: 10.4028/www.scientific.net/SSP.277.54.

9. Sobolev, V. V., & Usherenko, S. M. (2006). Shock-wave initiation of nuclear transmutation of chemical elements. Journal De Physique, IV, 977-982. DOI: 10.1051/jp4:2006134149.

10. Dychkovskyi, R., Vladyko, O., Maltsev, D., & Cabana, E. (2018). Some aspects of the compatibility of mineral mining technologies. Rudarsko Geolosko Naftni Zbornik, 33(4), 73-82. DOI: 10.17794/rgn.2018.4.7.

11. Pivnyak, G. (2018). Mathematical and Geomechanical Model in Physical and Chemical Processes of Underground Coal Gasification, Solid State Phenomena, (277), 1-16. DOI: 10.4028/www.scientific.net/SSP.277.1.

12. Malanchuk, Z., & Malanchyk, Ye. (2018). Substantiation into mass and heat balance for underground coal gasification in faulting zones. Inzynieria Mineralna, 19(2), 289-300. DOI: 10.29227/IM-2018-02-36.

13. Dychkovskyi, R. O. (2015). Forming the bilayer artificially shell of georeactor in underground coal gasification. Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, 5, 37-42.

14. Dychkovskyi, R. O. (2015). Determination of the rock subsidence spacing in the well underground coal gasification. Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, 6, 30-36.

15. Kuttykadamov, M. E., Rysbekov, K. B., Milev, I., Ysty­kul, K. A., & Bektur, B. K. (2016). Geodetic monitoring methods of high-rise constructions deformations with modern technologies application. Journal of Theoretical and Applied Information Technology, 93(1), 24-31.

16. Sotskov, V., & Saleev, I. (2013). Investigation of the rock massif stress strain state in conditions of the drainage drift overworking. Annual Scientific-Technical Colletion ‒ Mining of Mineral Deposits, 197-201. DOI: 10.1201/b16354-36.

17. Jadhav, J. R., Mantha, S. S., & Rane, S. B. (2014). Roadmap for Lean implementation in Indian automotive component manufacturing industry: comparative study of UNIDO Model and ISM Model. Journal of Industrial Engineering International, 11(2), 179-198. DOI: 10.1007/s40092-014-0074-6.

18. Ilyashov, M., Diedich, I., & Nazimko, V. (2019). Prospective tendencies of coal mining risk management. Mining of Mineral Deposits, 13(1), 111-117. DOI: 10.33271/mining13.01.111.

19. Dychkovskyi, R. O., Avdiushchenko, A. S., Falshtynskyi, V. S., & Saik, P. B. (2013). On the issue of estimation of the coal mine extraction area economic efficiency. Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, 4, 107-114.

20. Piwniak, G. G. (2007). Limits to economic viability of extraction of thin coal seams in Ukraine. Technical, Technological and Economic Aspects of Thin-Seams Coal Mining International Mining Forum 2007, 129-132. DOI: 10.1201/noe0415436700.ch16.

 повний текст / full article



Visitors

6227474
Today
This Month
All days
1306
54151
6227474

Guest Book

If you have questions, comments or suggestions, you can write them in our "Guest Book"

Registration data

ISSN (print) 2071-2227,
ISSN (online) 2223-2362.
Journal was registered by Ministry of Justice of Ukraine.
Registration number КВ No.17742-6592PR dated April 27, 2011.

Contacts

D.Yavornytskyi ave.,19, pavilion 3, room 24-а, Dnipro, 49005
Tel.: +38 (056) 746 32 79.
e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
You are here: Home About the journal concept of the journal EngCat Archive 2019 Contens №5 2019 Mining Technological, lithological and economic aspects of data geometrization in coal mining