Features of fuses operating in medium voltage instrument transformers protection
- Details
- Parent Category: 2026
- Category: Content №5 2026
- Created on 27 October 2026
- Last Updated on 27 October 2026
- Published on 30 November -0001
- Written by O. M. Grechko, Ye. I. Baida, Oleksandr H. Sereda, Olena H. Sereda, V. M. Buhaichuk
- Hits: 1404
Authors:
O. M. Grechko*, orcid.org/0000-0001-7872-8585, National Technical University “Kharkiv Polytechnic Institute”, Kharkiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Ye. I. Baida, orcid.org/0000-0003-0297-328X, National Technical University “Kharkiv Polytechnic Institute”, Kharkiv, Ukraine
Oleksandr H. Sereda, orcid.org/0009-0003-5243-3828, National Technical University “Kharkiv Polytechnic Institute”, Kharkiv, Ukraine
Olena H. Sereda, orcid.org/0000-0003-4658-9554, National Technical University “Kharkiv Polytechnic Institute”, Kharkiv, Ukraine
V. M. Buhaichuk, orcid.org/0000-0003-2236-1280, LLC “AVM AMPER”, Kremenchuk, Ukraine.
* Corresponding author e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu. 2026, (5): 092 - 100
https://doi.org/10.33271/nvngu/2026-5/092
Abstract:
The problem of protection of 6–35 kV voltage instrument transformers (VTs) of using fuses is associated with the lack of domestic manufacturers of fuses capable of effectively protecting VTs, especially when small overload currents flow.
Purpose. Establishing the characteristics of fuse operating when protecting medium voltage instrument transformers 6–35 kV with cast insulation and determining the technical parameters of improved fuses that provide effective protection of instrument transformers when small overload currents flow.
Methodology. Analytical and experimental methods were used to study the processes of fuse operating when protecting medium voltage instrument transformers. An analysis of the operating modes of 6–35 kV networks was carried out, the features of fuse operation at low overload currents were investigated, and laboratory experiments were performed to measure currents, voltages, and operating times. Based on the results obtained, criteria for selecting the parameters of improved fuses were formulated to increase the efficiency of transformer protection.
Findings. The results of the conducted experimental studies and oscillograms from operating power facilities confirmed the problem of disconnecting small overload currents of VTs by fuses. It was experimentally established that when fuses protecting VTs switch off small overload currents, the fuse-link burns out, but the VT power circuit is not interrupted and voltage remains at the terminals of its secondary winding.
Originality. Criteria for determining the parameters of fuses to increase the efficiency of VT protection are proposed and the feasibility of creating an improved fuse for VTs with a rated fuse-link current In 0.08–0.1 A, which ensures operating for 1 hour at a current I1h 0.15 А, is substantiated.
Practical value. Ways of solving the problem of VT protection are proposed by improving the designs of fuses in order to improve their protective characteristics in the range of small overload currents.
Keywords: fuse, fuse-link, medium voltage instrument transformer, instrument transformer protection, overvoltage, ferroresonance
References.
1. Zhurahivskyi, A. V., Kens, Y. A., Yatseyko, A. Y., & Maslyak, R. Y. (2013). Multi-protection system power grids 6–35 kV from ferroresonance processes. Technical Electrodynamics, (5), 70-76. http://previous.techned.org.ua/2013_5/st11.pdf
2. Zhurahivskyi, A. V., Kens, Y. A., Yatseyko, А. Y., & Maslyak, R. Y. (2010). Ferroresonance processes in electrical networks 10 kV with different voltage transformers. Technical Electrodynamics, (2), 73-78. http://previous.techned.org.ua/article/10-2/st9.pdf
3. Hanus, O., & Starkov, K. (2021). Study of the nature of overvoltages in the electrical network arising from voltage transformers. Bulletin of the National Technical University “KhPI”. Series: Energy: Reliability and Energy Efficiency, 1(2), 28-36. https://doi.org/10.20998/2224-0349.2021.01.05
4. Sayenko, Y. L., & Popov, A. S. (2011). Investigation of the damage cause of the voltage transformers using for insulation checking. Energy Saving. Power Engineering. Energy Audit, 7(89), 59-66. http://eee.khpi.edu.ua/article/view/21892
5. Malinovskyi, A. A., & Hushchyn, Ye. Yu. (2015). Network faults impact on operation of nom-10 voltage transformers. Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, (1), 89-93.
6. Wang, K., Liu, H., Yang, Q., Yin, L., & Huang, J. (2019). Impact Transient Characteristics and Selection Method of Voltage Transformer Fuse. Energies, 12(4), 737. https://doi.org/10.3390/en12040737
7. Bajda, Y., Grechko, O., Buhaichuk, V., & Knápek, R. (2021). To the Problem of Protection of Medium Voltage Instrument Transformers with Fuses: Analytical Research. Lighting Engineering & Power Engineering, 60(3), 92-102. https://doi.org/10.33042/2079-424X.2021.60.3.02
8. Bajda, Y., & Grechko, O. (2023). Multiphysics calculation of fuses of medium voltage measuring transformers. Bulletin of NTU “KhPI”. Series: Problems of Electrical Machines and Apparatus Perfection. The Theory and Practice, 1(9), 3-10. https://doi.org/10.20998/2079-3944.2023.1.01
9. El-Shafhy, M. (2022). Ferroresonance in Distribution Systems – State of the Art. Przeglad Elektrotechniczny, 11, 3-17. https://doi.org/10.15199/48.2022.11.01
10. Yang, M., Sima, W., Duan, P., Zou, M., Peng, D., Yang, Q., & Duan, Q. (2017). Electromagnetic transient study on flexible control processes of ferroresonance. International Journal of Electrical Power & Energy Systems, 93, 194-203. https://doi.org/10.1016/j.ijepes.2017.05.026
11. McDermit, D. C., Shipp, D. D., Dionise, T. J., & Lorch, V. (2013). Medium-Voltage Switching Transient-Induced Potential Transformer Failures: Prediction, Measurement, and Practical Solutions. IEEE Transactions on Industry Applications, 49(4), 1726-1737. https://doi.org/10.1109/TIA.2013.2258453
12. Pordanjani, I. R., Liang, X., Wang, Y., & Schneider, A. (2021). Single-Phase Ferroresonance in an Ungrounded System During System Energization. IEEE Transactions on Industry Applications, 57(4), 3530-3537. https://doi.org/10.1109/TIA.2021.3079878
13. Saienko, Y. L., & Popov, A. S. (2010). Determination of the boundaries of existence of ferroresonance in the network with the insulated neutral and the electromagnetic voltage transformers VTOI-6-66 on the basis on the computer simulation. Energy Saving. Power Engineering. Energy Audit, 12(82), 9-16. https://eee.khpi.edu.ua/article/view/23019
14. Saienko, Yu. L., & Popov, A. S. (2011). Simulation of ferroresonance phenomenon in distribution networks of metallurgical enterprises. Visnyk of Vinnytsia Politechnical Institute, (2), 91-95.
https://visnyk.vntu.edu.ua/index.php/visnyk/article/view/1400/1400
15. ABB. Ferroresonance elimination VT Guard Pro (n.d.). https://new.abb.com/medium-voltage/apparatus/instrument-transformers-and-sensors-id/products/iec-indoor-voltage-transformers/ferroresonance-elimintation-vt-guard-pro
16. Orion EE. Ferro-Damp. Ferroresonance Solutions (n.d.). https://orionee.com/products/ferroresonance-solution/ferro-damp
17. Saienko, Yu. L., & Popov, A. S. (2012). Investigated ferroresonance processes without ground fault. Technical Electrodynamics, (6), 51-57. https://techned.org.ua/index.php/techned/article/view/1398/1280
18. Tugay, Yu. I., Ganus, O. I., & Starkov, K. О. (2016). The switching in voltage transformer. Technical Electrodynamics, (5), 73-75. https://doi.org/10.15407/techned2016.05.073
19. LLC “QUARTZ”. Current-limiting fuses of the PKT and PKN series. Technical description and operating instructions UICG.674351.004 (n.d.). https://quartz.zp.ua/uploads/files/products/pkt_pkn_ua.pdf
20. LLC “Energozahyst”. High-voltage fuses of the PK(n) series (n.d.). https://energozahist.com.ua/catalog/high-voltage-fuses/p-511
21. DSTU EN 60282-1:2016. High-voltage fuses. Part 1. Current-limiting fuses (EN 60282-1:2009, IDT). With corrections no. 1, 2016.
22. International Electrotechnical Commission (2020). High-voltage fuses – Part 1: Current-limiting fuses (IEC Standard No. 60282-1:2020). (n.d.). https://webstore.iec.ch/publication/59817
23. Grechko, O., & Kulyk, O. (2024). Current State and Future Prospects of Using SF6 Gas as an Insulation in the Electric Power Industry. 2024 IEEE 5 th KhPI Week on Advanced Technology (KhPIWeek), Kharkiv, Ukraine, 2024, (pp. 1-6). https://doi.org/10.1109/KhPIWeek61434.2024.10877987
24. LZQJ-XC. 4-quadrant/combined meter (n.d.). https://emh-metering.com/en/products/special-meters/lzqj-xc
25. Technical information for CheckMeter 2.3 genX (n.d.). https://www.mte.ch/products/checkmeter-23-genx-411/portable-test-equipment/checkmeter-23-genx-397
Newer news items:
- Strategic imperatives for the development of public administration in the context of digitalization: methodological and legal aspects - 27/10/2026 08:38
- Trends in the formation and development of personnel potential in the context of transformational changes in the economy of Ukraine - 27/10/2026 08:38
- EU transport policy: challenges for the development of Ukrainian legislation - 27/10/2026 08:38
- Application of Google Earth Engine to automated surface water quality monitoring in the Red River and Duong River basins - 27/10/2026 08:38
- Criminal law analysis of occupational safety violations in Ukraine - 27/10/2026 08:38
- A novel WIF–ESH framework for environmental hazard zoning of mining aerosols in semi-arid environments - 27/10/2026 08:38
- Financing environmental protection in the context of ensuring ecologically balanced development of Ukraine - 27/10/2026 08:37
- Research on diversification and resilience of the energy mix to ensure energy transition - 27/10/2026 08:37
- Increasing fuel efficiency of waste incombustion boiler plants - 27/10/2026 08:37
- Linguistic mathematical model for assessing the technical condition of high-voltage circuit breakers based on monitoring data - 27/10/2026 08:37
Older news items:
- Energy-based assessment of the survivability of structural systems under accidental actions - 27/10/2026 08:37
- Improving the dynamic stability of wagons when transporting rock mass - 27/10/2026 08:37
- 3D simulation of longwall-gateroad interaction in close coal seams - 27/10/2026 08:37
- Geomechanical model of floor heave in long deep underground excavations - 27/10/2026 08:37
- Dephosphorization of the oolitic iron ore from Gara Djebilet using combined methods - 27/10/2026 08:37
- Determination of the viscosity of ore pulp using a piezoelectric transducer - 27/10/2026 08:37
- The impact of the collective concentrate factory location on the circular mining technology for titanium-zirconium deposit - 27/10/2026 08:37
- Analysis of the state of research on blast energy management of borehole charges - 27/10/2026 08:37
- Petrographic and geochemical study of magmatic rocks in the Souk El Thenine region - 27/10/2026 08:37
- Influence of folding intensity on the formation of technogenic hydrocarbon accumulations - 27/10/2026 08:37



