Radiometric sorting techniques for mining wastes from Ouenza iron mine (Algeria)
/ 0
- Details
- Parent Category: Contents №5 2018
- Category: Solid State Physics, Mineral Processing
- Created on 29 October 2018
- Last Updated on 08 November 2018
- Published on 29 October 2018
- Written by Super User
- Hits: 3210
Authors:
D.Baala, Badji Mokhtar University, Annaba, Algeria, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
A.Idres, Dr. Sc. (Tech.), Prof., Badji Mokhtar University, Annaba, Algeria, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
M.Bounouala, Dr. Sc. (Tech.), Prof., Badji Mokhtar University, Annaba, Algeria, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
A.Benselhoub, Cand. Sc. (Ecolog.), State and Agrarian and Economic University, Dnipro, Ukraine
Abstract:
Purpose. The research work deals with the characterization and the valorisation of waste rocks from Ouenza iron mine by physical methods. The chemical and mineralogical analyses carried out on the three categories taken from the dumps, allow us to distinguish three categories of materials on all the landfill sites, namely: hematite, which represents 30 %, marl 30 %, and limestone 40 %. These cause a problem of management and distribution of rocks at the surface. The objective of this research is to search for ways of removing the waste rocks from the iron mine of Ouenza.
Methodology. To identify these waste rocks, a characterization was performed by XRD of the different categories and the initial sample, the chemical analysis of the three categories of materials from the dumps of Ouenza iron mine by FX. Tests to measure the mass attenuation coefficient of waste rocks samples by transmitting a g-beam in thin geometry were applied. Attenuation was studied for the 122, 244, 344 and 661 KeV energies emitted by the point sources of 152Eu and 137Cs, respectively.
Findings. Different raw samples were analysed by DRX and FX. The obtained results show that the mineralogical composition includes: calcite, quartz and hematite. The best results are achieved with the following parameters: the thickness of the samples between 80 and 90 mm, the sample captures the whole gamma beam, and the range of energies is between 122 and 661 KeV, which strongly contributes to the radiometric separation of waste rocks from the iron mine of Ouenza, Algeria.
Originality. It is possible to apply the radiometric method. This process allows selective sorting of the waste rocks of Ouenza using g-rays at different energies, taking into account the thickness and the iron content of the samples. The separation technique is simple and economical and does not require investments in heavy industrial equipment.
Practical value. Iron ore is in great demand in the global market. However, waste rocks must be sorted and valued so that the product is merchantable. The iron ore processed by the technique suggested meets industrial requirements and international standards, in particular, in the iron and steel industry; the iron content is 67.13 %.
References.
1. Aubertin, M., Bussière, B., Pabst, T., James, M. and Bonimpa, M., 2016. Review of the reclamation techniques for acid-generating mine wastes upon closure of disposal sites. In: Geo-Chicago 2016, pp. 343‒358.
2. Benselhoub, A., Kharytonov, M., Bounouala, M., Chaabia, R. and Badjoudj, S., 2015. Estimation of soil’s sorption capacity to heavy metals in Algerian megacities: case of Algiers and Annaba. INMATEH-Agricultural Engineering, 46(2), pp. 147‒154.
3. Kharytonov, M., Benselhoub, A., Klimkina, I., Bouhedja, A., Idres, A. and Aissi, A., 2016. Air pollution mapping in the Wilaya of Annaba (NE of Algeria). Mining Science, 23.
4. Idres, A., Abdelmalek, C., Bouhedja, A., Benselhoub, A. and Bounouala, M., 2017. Valorization of mining waste from Ouenza iron ore mine (eastern Algeria). REM-International Engineering Journal, 70(1), pp. 85‒92.
5. Kobzev, A. S., 2013. Directions of development and problems of radiometric methods for the enrichment of mineral raw materials. Enrichment of ores, 1, pp. 13‒17.
6. Mann, K. S., 2018. Measurement of exposure buildup factors: The influence of scattered photons on gamma-ray attenuation coefficients. Nuclear Instruments and Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 877, pp. 1‒8.
7. Ozyurt, O., Altinsoy, N., Karaaslan, Ş. İ., Bora, A., Buyuk, B. and Erk, İ., 2018. Calculation of gamma ray attenuation coefficients of some granite samples using a Monte Carlo simulation code. Radiation Physics and Chemistry, 144, pp. 271‒275.
8. Taqi, A. H. and Khalil, H. J., 2017. An investigation on gamma attenuation of soil and oil-soil samples. Journal of Radiation Research and Applied Sciences, 10(3), pp. 252‒261.
9. Haber, D. A., Malchow, R. L. and Burnley, P. C., 2017. Monte Carlo simulations of the gamma-ray exposure rates of common rocks. Journal of environmental radioactivity, 167, pp. 20‒25.
10. Medhat, M. E. and Abdel-Hafiez, A., 2016. Application of Gamma-Ray Attenuation in Studying Soil Properties. Physical Science International Journal, 10(2), pp. 1‒6.
11. Ferreira, T. R., Pires, L. F., Brinatti, A. M. and Auler, A. C., 2017. Surface liming effects on soil radiation attenuation properties. Journal of Soils and Sediments, 17, pp. 1‒13.
12. Azaryan, A., 2015. Research of influence of monocrystal thickness NAJ (TL) on the intensity of the integrated flux of scattered gamma radiation. Metallurgical and Mining Industry, 2, pp. 43‒46.
13. Morkun, V. and Tron, V., 2014. Automation of iron ore raw materials beneficiation with the operational recognition of its varieties in process streams. Metallurgical and Mining Industry, 6, pp. 4‒7.
