Articles

Regime-parametric optimization of a mine winder deceleration

User Rating:  / 0
PoorBest 

Authors:

V.S.Loveikin, Dr. Sc. (Tech.), Prof., orcid.org/0000-0003-4259-3900, National University of Life and Environmental Sciences of Ukraine, Kyiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.; This email address is being protected from spambots. You need JavaScript enabled to view it.

Yu.О.Romasevych, Dr. Sc. (Tech.), Assoc. Prof., orcid.org/0000-0001-5069-5929, National University of Life and Environmental Sciences of Ukraine, Kyiv, Ukraine, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.; This email address is being protected from spambots. You need JavaScript enabled to view it.

Abstract:

Purpose. Improving mine winder operation efficiency during deceleration of the final cargo lowering due regime-parametric optimization and study the obtained results with dynamic and energy indicators.

Methodology. In order to carry out the regime-parametric optimization of the mine winder deceleration mode the direct Euler’s variational and differential evolution methods have been used. In order to study the approximate solution of the variational problem the mathematical modeling and integration of differential equations methods were used.

Findings. It was established that in comparison with rational laws of the mine winder deceleration using the optimum torque law reduces unwanted dynamic loads in the rope up to 28.4 %, and in the coupling by 15.4...82.7 %. In this case, the oscillations of the drive and the final cargo at the end of deceleration do not exist. In aggregate, it allows increasing the reliability of the mine winder. The optimal value of the reduced coefficient of coupling stiffness of the mine winder actuator has been established.

Originality. The formulation of an optimization problem has been carried out. The complex terminal-integral criterion has been chosen. It was shown that in the formulation of the problem it is necessary to introduce the extra boundary conditions for achieving the absolute minimums of the terminal criteria. In order to find an approximate solution to the mine winder deceleration mode optimization problem, sampling of the problem was carried out. The solution of the problem was found on a set, which is the conjunction of two domains: the dynamic parameters of the mine winder and its modes of motion.

Practical value. The calculated optimal deceleration mode of the machine may be implemented with the frequency-controlled drive, which allows increasing the efficiency of the mine winder operation in terms of dynamic indicators.

References.

1. Wolny, S., 2017. Emergency braking of a mine hoist in the context of the braking system selection. Archives of Mining Sciences, 62(1), pp. 45‒54. DOI: 10.1515/amsc-2017-0004.

2. Dagang, W., Dekun, Z. and Shirong, G., 2014. Effect of terminal mass on fretting and fatigue parameters of a hoisting rope during a lifting cycle in coal mine. Engineering Failure Analysis, 36, pp. 407‒422. DOI: 10.1016/j.engfailanal.2013.11.006.

3. Chenming, W., Jisheng, W., Bo, D., Iitao, F. and Shengli, Z., 2016. The Influence to Mine Hoisting Steel Wire Rope Tension and Deformation from Velocity and Acceleration. International Conference on Manufacturing Science and Information Engineering, pp. 296‒306. DOI: 10.12783/dtcse/icmsie2016/6345.

4. Dagang, W., Dekun, Z., Xianbiao, M., Yuxing, Р. and Shirong, G., 2015. Dynamic friction transmission and creep characteristics between hoisting rope and friction lining. Engineering Failure Analysis, 57, pp. 499‒510. DOI: 10.1016/j.engfailanal.2015.08.010.

5. Jun, Z., Dagang, W., Dekun, Z., Shirong, G. and Dao’ai, W., 2017. Dynamic torsional characteristics of mine hoisting rope and its internal spiral components. Tribology International, 109, pp. 182‒191. DOI: 10.1016/j.triboint.2016.12.037.

6. Chao, J., Yanshu, L., Bohua, W., Shuangshuang, Z. and Xue, L., 2013. Research on nonlinear dynamical behaviors of mine hoist transmission system under external excitation. Advanced Materials Research, 619, pp. 9‒13. DOI: 10.4028/www.scientific.net/AMR.619.9.

7. Yao, J., Xiao, X., Peng, A., Jiang, Y. and Ma, C., 2015. Assessment of safety for axial fluctuations of head sheaves in mine hoist based on coupled dynamic model. Engineering Failure Analysis, 51, pp. 98‒107. DOI: 10.1016/j.engfailanal.2015.02.011.

8. Illin, S. R., Samusia, V. I., Ilina I. S. and Ilina, S. S., 2016. Influence of dynamic processes in mine hoists on safety of exploitation of shafts with broken geometry. Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, 3, pp. 48‒53.

9. Dai, Y. and Qiao, S., 2014. The Design of Mine Hoist Speed Regulation System Based on Ziegler-Nichols PID Control. Applied Mechanics and Materials, 651–653, рр. 996‒999.

10. Wu, Y. X., Zhang, C. J. and Liu, Y. Q., 2013. Design and Simulation of Fuzzy-PID Vector Control System Based on Mine Hoist. Applied Mechanics and Materials, 300-301, pp. 1486‒1489. DOI: 10.4028/www.scientific.net/AMM.300-301.1486.

11. Szymański, Z., 2015. Intelligent, energy saving power supply and control system of hoisting mine machine with compact and hybrid drive system. Archives of Mining Sciences, 60(1), pр. 239‒251. DOI: 10.1515/amsc-2015-0016.

12. Yang, Z. S. and Ma, X. M., 2014. Synthesis of Mine Hoist Speed Curve Based on programmable logic controller. Advanced Materials Research, 846‒847, pp. 90‒ 93. DOI: 10.4028/www.scientific.net/AMR.846-847.90.

13. Zewen, W., Wei, L., Baoyu, C. and Fan, J., 2012. Design of the Remote Monitoring System for Mine Hoists. In: 24th Chinese Control and Decision Conference, pp. 3540‒3544. DOI: 10.1109/CCDC.2012.6244567.

14. Huaizhong, C., 2012. Study on PROFIBUS-DP Field Bus in Mine Hoists Control System. Advanced Materials Research, 482‒484, pp. 1781‒1784. DOI: 10.4028/www.scientific.net/AMR.482-484.1781.

15. Loveikin, V. S., Chovniuk, Yu. V. and Liashko, A. P., 2014. The crane’s vibrating systems controlled by mechatronic devices with magnetorheological fluid: the nonlinear mathematical model of behavior and optimization of work regimes.Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, 6, pp. 97‒102.

16. Loveikin, V. S. and Romesevych, Yu. O., 2017. Dynamic optimization of a mine winder acceleration mode. Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, 4, pp. 81‒87.

17. Bronshtein, I. N. and Semendyayev, K. A., 2013. Handbook of mathematics. 3rd ed. Springer Science & Business Media [online]. Available at: <https://www.springer.com/gp/book/9783662462201> [Accessed 25 September 2017].

18. Gander, M. J. and Wanner, G., 2012. From Euler, Ritz, and Galerkin to Modern Computing. SIAM REVIEW [online], 54, 4. Available at: <http://www.siam.org/journals/sirev/54-4/80403.html> [Accessed 11 August 2017].

19. Storn, R., 2014. Differential Evolution (DE) for Continuous Function Optimization (an algorithm by Kenneth Price and Rainer Storn) [online]. Available at: <http://www1.icsi.berkeley.edu/~storn/code.html> [Acce­ssed 5 September 2017].

20. Prasad, H., Maity, T. and Babu, V. R., 2015 Recent developments in mine hoists drives. Journal of Mining Science, 51(6), pp. 1157–1164.

 повний текст / full article



Visitors

6227524
Today
This Month
All days
1356
54201
6227524

Guest Book

If you have questions, comments or suggestions, you can write them in our "Guest Book"

Registration data

ISSN (print) 2071-2227,
ISSN (online) 2223-2362.
Journal was registered by Ministry of Justice of Ukraine.
Registration number КВ No.17742-6592PR dated April 27, 2011.

Contacts

D.Yavornytskyi ave.,19, pavilion 3, room 24-а, Dnipro, 49005
Tel.: +38 (056) 746 32 79.
e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
You are here: Home