The character of disruption of the rocks surface during rapid cooling

User Rating:  / 1
PoorBest 

Authors:

D. L. Vasyliev, orcid.org/0000-0001-6864-357X, Institute of Geotechnical Mechanics named by N. Poljakov, Dnipro, Ukraine, e­mail: This email address is being protected from spambots. You need JavaScript enabled to view it.">This email address is being protected from spambots. You need JavaScript enabled to view it.

V. F. Hankevych, orcid.org/0000-0002-8535-6318, Dnipro University of Technology, Dnipro, Ukraine, e­mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

T. V. Moskalova, orcid.org/0000-0002-5352-8891, Dnipro University of Technology, Dnipro, Ukraine, e­mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

O. V. Livak, orcid.org/0000-0002-5552-6531, Ukrainian State University of Chemical Technology, Dnipro, Ukraine, e­mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

повний текст / full article

 

Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu. 2020, (5): 061-067

https://doi.org/10.33271/nvngu/2020-5/061

Abstract:

Purpose. The purpose of this study is investigation of the patterns of occurrence of the system of macro- and microcracks in the rocks during rapid cooling for their effective softening.

Methodology. The solution of the problem of crack system development is based on the fact that, as a result of rapid cooling in the surface layer of the rock, the tensile stresses are developed. The stretched layer acquires potential energy, depending on the modes of thermal influence and rock properties. At a certain point, the energy of the stretched layer starts to be spent on the formation of new surfaces of the growing system of macro- and microcracks.

Findings. A model of behavior of the surface layer of rocks in the conditions of thermal shock by cooling is proposed. This model takes into account the development of a fracture macrocrack system and a microcrack system that move in the layer behind the cooling front. The dependence has been obtained that allows determining the penetration depth of a macrocrack system in the rock depending on the thermal exposure regimes and the physical and mechanical properties of the rocks. The formation of a microcrack system in the stretched cooled surface layer which changes its strength properties is experimentally proved. It is shown that the system of macrocracks moves into the array with deceleration and penetrates into the rock deeper than the thickness of the cooled layer, while microcracks are formed within the extended cooled layer. It is shown that the penetration depth of the macrocrack system into the rock is practically independent of the mode of thermal shock by cooling and is determined by the physical and mechanical properties of the rock and the time of exposure. Increasing the potential energy of the stretched rock layer due to an increase in the temperature difference between heating and cooling (“toughening” of the thermal shock regime) leads mainly to an increase in the density of a cracking net on the rock surface.

Originality. For the first time the development of a crack system rather than a single crack in a rock during rapid cooling was considered. The model of the rock surface layer behavior under the conditions of rapid cooling is proposed. The geometric aspects of the initiation and propagation of a macrocrack system into the rock due to thermocycling loading are considered. The fact of initiation of a microcrack system along with macrocracks which change the strength properties of rock in the formation zone is proved.

Practical value. The analytical dependence is obtained that allows determining the penetration depth of a crack system in rocks as a result of thermal shock by cooling. This dependence makes it possible to estimate the size of the damaged by macro- and microcracks zone of a rock, as well as the degree of rock softening depending on its physical and mechanical properties and thermal shock modes of cooling. The results are used in real technological processes with thermocycling impact such as preparing rocks for mechanical destruction, hydraulic fracturing, loosening and explosive destruction.

References.

1. Gankevych, V. F., & Livak, O. V. (2017). Study on rock destruction processes using the temperature factor. Zbahachennia korysnykh kopalyn, (68), 46-55.

2. Yang, S. Q., Ranjith, P. G., Jing, H. W., Tian, W. L., & Ju, Y. (2017). An experimental investigation on thermal damage and failure mechanical behavior of granite after exposure to different high temperature treatments. Geothermics, 65, 180-197. https://doi.org/10.1016/j.geothermics.2016.09.008.

3. Su, H., Jing, H., & Du, M. (2016). Experimental investigation on tensile strength and its loading rate effect of sandstone after high temperature treatment. Arabian Journal of Geosciences, 9, 616. https://doi.org/10.1007/s12517-016-2639-8.

4. Yin, T., Li, X., & Cao, W. (2015). Effects of Thermal Treatment on Tensile Strength of Laurentian Granite Using Brazilian Test. Rock Mechanics and Rock Engineering, (48), 2213-2223. https://doi.org/10.1007/s00603-015-0712-3.

5. Sun, Q., Zhang, W., & Su, T. (2016). Variation of Wave Velocity and Porosity of Sandstone after High Temperature Heating. Acta Geophys. (64), 633–648. https://doi.org/10.1515/acgeo-2016-0021.

6. Wong, L. N. Y., Zhang, Y., & Wu, Z. (2020). Rock strengthening or weakening upon heating in the mild temperature range? Engineering Geology, (272). https://doi.org/10.1016/j.enggeo.2020.105619.

7. Tian, H., Ziegler, M., & Kempka, T. (2014). Physical and mechanical behavior of claystone exposed to temperatures up to 1000 °C. International Journal of Rock Mechanics and Mining Sciences, (70), 144-153. https://doi.org/10.1016/j.ijrmms.2014.04.014.

8. Mahanta, B., Singh, T. A., & Ranjith, P. G. (2016). Influence of thermal treatment on mode I fracture toughness of certain Indian rocks. Engineering Geology, (210), 103-114. https://doi.org/10.1016/j.enggeo.2016.06.008.

9. Yin, Q., Jing, H., & Liu, R. (2020). Pore characteristics and nonlinear flow behaviors of granite exposed to high temperature. Bulletin of Engineering Geology and the Environment, (79), 1239-1257. https://doi.org/10.1007/s10064-019-01628-6.

10. Dreus, A. Yu., Sudakov, A. K., Kozhevnikov, A. A., & Vakhalin, Yu. N. (2016). Study on thermal strength reduction of rock formation in the diamond core drilling process using pulse flushing mode. Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, (3), 5-10.

11. Kozhevnikov, A. A., Dreus, A. Yu., & Lee, B. (2017). The energy criterion of efficiency of diamond drilling with intermittent flush. Porodorazrushayushchiy i metalloobrabatyvayushchiy instrument – tekhnika i tekhnologiya yego izgotovleniya i primeneniya: Sbornik nauchnykh trudov, (20), 62-66.

12. Kozhevnikov, A. A., & Dreus, A. Yu. (2016). Analysis of the effectiveness of rock destruction during drilling with pulse flushing of wells. Porodorazrushayushchiy i metalloobrabatyvayushchiy instrument – tekhnika i tekhnologiya yego izgotovleniya i primeneniya: Sbornik nauchnykh trudov, (19), 62-66. http://dspace.nbuv.gov.ua/handle/123456789/139102.

13. Kozhevnikov, A. O., Kravets’, V. I., Vakhalin, Yu. M., & Livak, O. V. (2018). Patent of Ukraine No. 125672. Ukraine.

14. Kim, K., Kemeny, J., & Nickerson, M. (2014). Effect of Rapid Thermal Cooling on Mechanical Rock Properties. Rock Mechanics and Rock Engineering, (47), 2005-2019. https://doi.org/10.1007/s00603-013-0523-3.

15. Kozhevnikov, A. A., Krisan, V. V., Vakhalin, Yu. N., Tretiakov, O. A., & Livak, O. V. (2011). Destruction of rocks during shock cooling: monograph. Dnipropetrovsk: Lizunov Press LLC. ISBN 978-966-2575-03-3.

Visitors

6227518
Today
This Month
All days
1350
54195
6227518

Guest Book

If you have questions, comments or suggestions, you can write them in our "Guest Book"

Registration data

ISSN (print) 2071-2227,
ISSN (online) 2223-2362.
Journal was registered by Ministry of Justice of Ukraine.
Registration number КВ No.17742-6592PR dated April 27, 2011.

Contacts

D.Yavornytskyi ave.,19, pavilion 3, room 24-а, Dnipro, 49005
Tel.: +38 (056) 746 32 79.
e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
You are here: Home Authors and readers journal headlines EngCat Archive 2020 Contens №5 2020 The character of disruption of the rocks surface during rapid cooling