Impact of duration of mechanochemical activation on enhancement of zinc leaching from polymetallic ore tailings

User Rating:  / 0
PoorBest 

Authors:

V. I. Golik, orcid.org/0000-0002-1181-8452, Geophysical Institute of Vladikavkaz Scientific Centre of the Russian Academy of Sciences, Vladikavkaz, Russian Federation; North Caucasian Institute of Mining and Metallurgy (State Technological University), Vladikavkaz, Russian Federation, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Yu. V. Dmitrak, orcid.org/0000-0003-1278-4845, North Caucasian Institute of Mining and Metallurgy (State Technological University), Vladikavkaz, Russian Federation, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

V. S. Brigida, orcid.org/0000-0002-9421-5613, Federal Research Centre the Subtropical Scientific Centre of the Russian Academy of Sciences, Sochi, Russian Federation, e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

повний текст / full article

 

Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu. 2020, (5): 047-054

https://doi.org/10.33271/nvngu/2020-5/047

Abstract:

Purpose. Determination the impact of duration of mechanochemical activation on enhancement of zinc leaching from polymetallic ore tailings to ensure the sustainable mining.

Methodology. In experimental studies on the mechanical activation of geomaterial from the tails of Sadon polymetallic ores, the DESI-11 disintegrator was used. As a solution for leaching, a mixture with a different ratio of mass concentrations of hydrochloric and sulfuric acids was used. In addition, the ratio of solid and liquid fractions was varied from 1/4 to 1/10 with process duration of 15 to 60 minutes. The results were processed by the standard LOESS method in combination with three-dimensional interpolation of an incomplete data sample.

Findings. Polynomial dependences have been established that make it possible to calculate the degree of zinc extraction from the tail, depending on the parameters of the process of the leached solution, the ratio of the solid and liquid phases in the pulp and the duration of agitation leaching.

Originality. For the first time, the mechanism of surface transformation, size and location of zones with maximum leaching efficiency with small changes in the duration of mechanical activation of the pulp was clarified.

Practical value. The revealed patterns can be used to optimize the parameters of agitation leaching by correlating the cost of energy consumption for increasing the duration of the process and unit costs for the lixiviants.

References.

1. Komashchenko, V. I., Vorobev, E. D., & Razorenov, Y. I. (2017). Extraction of metals when recycling enrichment of ores. Bulletin of the Tomsk Polytechnic University, Geo Assets Engineering, 328(10), 18-24. http://earchive.tpu.ru/handle/11683/43364.

2. Rakishev, B. R., Bondarenko, V. I., Matayev, M. M., & Kenzhetayev, Z. S. (2019). Influence of chemical reagent complex on intensification of uranium well extraction. Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, (6), 25-30. https://doi.org/10.29202/nvngu/2019-6/4.

3. Golik, V., Komashchenko, V., & Morkun, V. (2015). Feasibility of using the mill tailings for preparation of self-hardening mixtures. Metallurgical and Mining Industry, (3), 38-41.

4. Minagawa, M., Hisatomi, Sh., Kato, T., Granata, G., & Tokoro, Ch. (2018). Enhancement of copper dissolution by mechanochemical activation of copper ores: Correlation between leaching experiments and DEM simulations. Advanced Powder Technology, 29(3), 471-478. https://doi.org/10.1016/j.apt.2017.11.031.

5. Bouabdallah, S., Bounouala, M., Idres, A., & Chaib, A. (2015). Iron removal process for high-purity silica production by leaching and magnetic separation technique. Naukovyi Visnyk Natsionalnoho Hirnychoho Universytetu, (5), 47-52.

6. Chen, G., Chen, J., & Peng, J. (2015). Effect of mechanical activation on structural and microwave absorbing characteristics of high titanium slag. Powder Technology, 286, 218-222. https://doi.org/10.1016/j.powtec.2015.08.021.

7. Basturkcua, H., Achimovičováb, M., Kaňuchovád, M., & Acarkana, N. (2018). Mechanochemical pre-treatment of lateritic nickel ore with sulfur followed by atmospheric leaching. Hydrometallurgy, 181, 43-52. https://doi.org/10.1016/j.hydromet.2018.08.016.

8. Palaniandy, S. (2015). Impact of mechanochemical effect on chalcopyrite leaching. International Journal of Mineral Processing, 136, 56-65. https://doi.org/10.1016/j.minpro.2014.10.005.

9. Yushkova, O. V., Isaeva, L. A., Polyakov, P. V., & Avvakumov, E. G. (2018). The influence of mechanical activation on the dust index and the dissolution rate of alumina in the molten cryolite. Tsvetnye Metally, 8, 63-68. https://doi.org/10.17580/tsm.2018.08.08.

10. Sergeenko, S. N. (2019). Kinetics of dispersion-agglomeration processes during mechanical activation of the charge of 110g13 powder steel. Chernye Metally, (7), 47-52.

11. Bondarenko, V., Kovalevska, I., Astafiev, D., & Malova, O. (2018). Effect of mechanoactivated chemical additives on the process of gas hydrate formation. Eastern-European Journal of Enterprise Technologies, 1, 6(91), 17-26. https://doi.org/10.15587/1729-4061.2018.123885.

12. Yusupov, T. S., Kirillova, E. A., Shumskaya, L. G., Isupov, V. P., & Lyakhov, N. Z. (2017). Improvement of flotation enrichment of copper-nickel ores based on the selective destruction of mineral aggregates in high-energy impact. Chemistry for Sustainable Development, 4, 422-428. https://doi.org/10.15372/CSD20170413.

13. Golik, V., Morkun, V., Morkun, N., & Tron, V. (2019). Investigation of mechanochemical leaching of non-ferrous metals. Acta Mechanica et Automatica, 13(2), 113-123. https://doi.org/10.2478/ama-2019-0016.

14. Basturkcua, H., Acarkan, N., & Gock, E. (2017). The role of mechanical activation on atmospheric leaching of a lateritic nickel ore. International Journal of Mineral Processing, 163, 1-8. https://doi.org/10.1016/j.minpro.2017.04.001.

15. Yushkova, O. V., Yasinskiy, A. S., Polyakov, P. V., & Yushkov, V. V. (2020). Use of mechanical activation to improve the performance of anode cover material. Tsvetnye Metally, 1(925), 54-59. https://doi.org/10.17580/tsm.2020.01.08.

16. Bumanisa, G., & Bajarea, D. (2017). Compressive strength of cement mortar affected by sand microfiller obtained with collision milling in disintegrator. Procedia Engineering, 172, 149-156. https://doi.org/10.1016/j.proeng.2017.02.037.

17. Dvořák, K., Dolák, D., Paloušek, D., Čelko, L., & Jech, D. (2018). The effect of the wear of rotor pins on grinding efficiency in a high-speed disintegrator. Medziagotyra, 24(1), 29-34. https://doi.org/10.5755/j01.ms.24.1.17737.

18. Morkun, V. S., Morkun, N. V., Tron, V. V., Hryshchenko, S. M., Suvorov, O. I., Paraniuk, D. I., & Serdiuk, O. J. (2019). Reducing dimension of spatio-temporal models of nonlinear dynamic processes of iron ore raw materials enrichment. Bulletin of the Tomsk Polytechnic University. Geo Assets Engineering, 330(12), 151-167. https://doi.org/10.18799/24131830/2019/12/2416.

19. Brigida, V. S., Golik, V. I., Dmitrak, Yu. V., & Gabaraev, O. Z. (2019). Ensuring stability of undermining inclined drainage holes during intensive development of multiple gas-bearing coal layers. Journal of Mining Institute, 239, 497-501. https://doi.org/10.31897/PMI.2019.5.497.

20. Gu, H., Guo, T., Wen, H., Luo, Ch., Cui, Y., Du, Sh., & Wang, N. (2020). Leaching efficiency of sulfuric acid on selective lithium leachability from bauxitic claystone. Minerals Engineering, 145(106076). https://doi.org/10.1016/j.mineng.2019.106076.

Visitors

6237533
Today
This Month
All days
1987
64210
6237533

Guest Book

If you have questions, comments or suggestions, you can write them in our "Guest Book"

Registration data

ISSN (print) 2071-2227,
ISSN (online) 2223-2362.
Journal was registered by Ministry of Justice of Ukraine.
Registration number КВ No.17742-6592PR dated April 27, 2011.

Contacts

D.Yavornytskyi ave.,19, pavilion 3, room 24-а, Dnipro, 49005
Tel.: +38 (056) 746 32 79.
e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
You are here: Home Authors and readers EngCat Archive 2020 Contens №5 2020 Impact of duration of mechanochemical activation on enhancement of zinc leaching from polymetallic ore tailings